Problem
Potential solutions
No breast milk is being
pumped.
Pumping the breast milk is
causing pain.
The breast milk is leaking
out underneath the silicone
cushion.
One of the device compo-
nents has become altered
or damaged.
The device will not switch
on.
6. Guarantee
This device is covered by a 2 year guarantee from the date of
purchase. The guarantee is valid only on presentation of the guar-
antee card completed by the dealer (see back) confirming date of
purchase or the receipt.
The guarantee covers the device. Batteries and packaging are
not included.
Opening or altering the device invalidates the guarantee.
The guarantee does not cover damage caused by improper
handling, discharged batteries, accidents or non-compliance
with the operating instructions.
Please contact Microlife-service.
8
Check that the silicone tube is correctly
inserted, the device is switched on and
the suction level is not set to the
minimum.
Ensure that there is no milk remaining
in the silicone valve and obstructing
the milk flow.
Try to relax and then attempt it again a
few minutes later. As you use the
device more and more, you will find it
easier to pump milk.
Set the suction level to MIN.
Consult your doctor.
Remove the silicone cushion and re-
attach it. Ensure the silicone cushion is
correctly positioned and firmly secured
to the pump attachment.
Lean your upper body forwards slightly.
Do not use any corrosive, gaseous
cleaning agents or solvents.
In some cases, marked fluctuations in
temperature can damage the plastic
on the device.
If any of the parts becomes damaged,
stop using the device.
Ensure that the device is correctly
assembled and switched on as
described in this instruction manual.
Ensure that the mains part plug is
correctly connected to the device.
7. Technical Specifications
Type:
Electric Breast Pump BC 200 Comfy
Dimensions:
130 x 120 x 57 mm
Weight:
330 g (without batteries)
Maximum
suction
pressure:
-0.32 bar
Operating
5 - 40 °C
conditions:
30 - 85 % relative maximum humidity
(non condensing)
700 - 1060 hPa ambient pressure
Storage
-20 - +60 °C
conditions:
10 - 95 % relative maximum humidity
(non condensing)
700 - 1060 hPa ambient pressure
Power source: 4 x 1.5 V alkaline batteries; size AA
AC adapter:
Input: 100-240V AC 50/60Hz 0.5A
Output: 6V DC 1.0 A
Battery lifetime: 500 hours
IP Class:
IP21
Expected
service life:
500 hours
Operating
limits:
30 min. On / 30 min. Off
Useful life of accessories subject to the conditions of cleanli-
ness and conservation
Electronic compatibility in accordance with EN 60601-1-2
Safety requirements in accordance with EN 60601-1
Child use and care articles - Drinking equipment according to
EN 14350
Unit for suction of breast milk
Unit for medium vacuum and low flow
Class II equipment (safety insulation)
Unit suitable for use in the absence of atmosphere containing
oxidising, exploding gases, nitrous oxide
BF type equipment (unit with specific grade of protection
against electrical hazards). Unit suitable for use in the
absence of atmospheres containing oxidising, explosive
gases or nitrous oxide.
The technical specifications may change without prior
notice.