Watching Tv; Channel Selection; Volume Adjustment; Switching Each Mode - Sylvania CT202SL8 Instrucciones

W
ATCHING TV

Channel Selection

Select channels by using [CH. K / L] or [the Number buttons].
• To select the memorized channels, use [CH. K / L] or
[the Number buttons].
• To select the non-memorized channels,
use [the Number buttons].
To Use [the Number buttons]
TV
- When selecting analog channel 12
DTV
- When selecting digital channel 12-1
• When you select a channel larger than 100,
press [+10/+100] first.
Then use [the Number buttons] to press the lower
2-digit numbers.
About digital TV broadcasting:
With its high definition broadcast, digital broadcasting
far surpasses analog broadcasting in both its picture
and sound quality.
What is the minor channel?
By using high compression technology, digital broad-
casting offers a service that enables multiple signals to
send simultaneously.
Therefore, you can select more than one program per
major channel since digital broadcasting technology
distinguishes between multiple channels broadcast by
a single network.
NTSC (analog mode) [Air Time]
CH4
: change automatically
: change manually by using [CH.
Although, you cannot watch the high definition TV
(HDTV) program, the unit converts the HDTV signal
down to the standard definition TV signal.
Note:
• "NO SIGNAL" will appear on the TV screen after the minor
channel broadcast is over.
ATSC (digital mode)
18:00
CH4 No signal No signal
18:30
CH4
(high definition TV)
19:00
CH4 CH4-1 No signal
19:30
CH4 No signal CH4-2
20:00
CH4 CH4-1 CH4-2
20:30
minor channel
major channel
/ ]

Volume Adjustment

This section describes how to adjust the volume. The mute function, which
turns the sound off and on, is also described.
Use [VOL. X / Y ] to adjust the audio volume.
• The volume bar will be displayed at the bottom of the
TV screen when adjusting the volume.
• The volume bar display will automatically disappear in
a few seconds.
Press [MUTE] to turn off and on the sound.
• "MUTE" is displayed on the TV screen.
Press [MUTE] again or use [VOL. X / Y ] to recover the
original volume.

Switching Each Mode

You can easily switch with the remote control to the DTV (ATSC), TV (NTSC)
and DVD mode or to access an external device when they are connected to
the unit.
Press [SELECT] repeatedly to cycle through analog TV,
digital TV, AUX (external input) and DVD.
AUX (EXTERNAL INPUT MODE)
• To use the video input jack on the front of the unit,
select "AUX".
Note:
• When you switch the analog mode to the digital mode, it
may take a while until the digital channel selection is com-
pleted. "NOW SCANNING" is displayed while switching the
mode.
VOLUME 20
MUTE 20
ANALOG MODE
DIGITAL MODE
DVD MODE
EN
15