Check the state of contamination of the particulate air filter (3) and replace it if required.
Last but not least, check the activated-carbon filter (4) and replace it if required. The
activated-carbon filter is saturated if odour nuisances can be perceived or once the current
weight of the filter surpasses its original weight by approximately 25 %. The original filter
weight is 7000 g ±200 g. Its exact weight is marked on the filter itself.
Pack the removed filters into polyethylene bags and dispose them of.
Mount the filter and extraction system again.
Place the cover unit back on top and close all module fasteners
6.3 Waste management/taking out of service
Extracting filtered matters, the filter and extraction system and its extraction units are contaminated with
harmful particles.
Taking out of service a filter and extraction system, safe disassembly and disposal of the system itself
and of all potentially contaminated attachments is to be ensured.
Please observe the safety instructions at the "Filter replacement" chapter!
When disposing of a filter and extraction system, be aware of the complete filter equipment being
special waste having to be disposed of according to local regulations. Depending on the degree of
contamination of the system and its extraction elements, these might have to be disposed of as special
waste as well (waste code number 150202).
For the transport, all safety instructions specified at the "Transport" chapter are to be observed.
RoHS II/ WEEE declaration of conformity
On 03 January 2013, the directive 2011/65/EU of the European Union on the restriction of the use of
certain hazardous substances in electrical and electronic equipment became applicable. Namely, these
substances are:
•
Lead (Pb), 0.1%
•
Cadmium (Cd), 0.01%
•
Hexavalent chromium (CrVI), 0.1%
•
Polybrominated biphenyls (PBB), 0.1%
•
Polybrominated diphenyl ethers (PBDE), 0.1%
•
Mercury (Hg), 0.1%
•
Di(2-ethylhexyl)phthalate (DEHP), 0.1 %
•
Benzyl butyl phthalate (BBP), 0.1 %
•
Dybuthyl phthalate (DBP), 0.1 %
•
Di-isobutyl phthalate (DIBP), 0.1 %
TBH GmbH hereby declares that our products comply with RoHS and REACH.
The devices produced by TBH do not fall under the equipment categories specified by the German law
of electrical equipment ElektroG section 1 §2 in its version of 16 March 2005 nor by the WEEE directive
2011/65/EU Annex IA. They are classified as B2B devices. This has been confirmed by the registration
at the registry for used electrical equipment EAR ("Elektro-Altgeräte-Register").
WEEE registration No. DE 95487803
Maintenance
37