Keys; Relays - Elkron FKP500 Manual De Instalación

3.2 KEYS

Keys
<, >
∨, ∧
RESET
TEST LAMP
REARM SIREN
SILENCE SIREN
INCREASE DELAY
ACKNOWLEDGE
On the front end of FKP500 Consolle a mechanical key is present allowing to disable the keypad in order to
prevent improper use.
To disable the keypad, place the mechanical key to OFF; to enable it, place it to ON.
The keypad is only active after programming the presence of remote panel at control panel.
When the panel is acknowledged by control panel, and control panel checks for the panel to be present, on the top
of the display, at the left, characters "*" and "-" appear in turn.
For further information, refer to control panel programming manual.

3.3 RELAYS

FKP500 Consolle has a relay which is directly piloted by the control panel.
When the control panel goes into alarm condition 2, the relay is activated, instead when the control panel returns to
normal operating conditions the relay is released.
Description
Selection of the event type shown on the display.
Rotation of messages shown on the display.
Control panel reset key (general reset). Enabled via a mechanical key
Key to test the lit indicators. It lights the indicators for 5 seconds.
Key for resetting the sirens if they were previously shut off when an alarm condition was
present. Enabled via a mechanical key.
Key for silencing sirens when an alarm condition is present. Enabled via a mechanical
key.
Key for increasing alarm delay when a timed alarm condition is present. Enabled via a
mechanical key.
Key for acquiring an event. Acquisition of an event requires silencing the panel and
control panel buzzers.
14/40
.
FKP500