Assembly - GOK GS Pro-Fi 3 Instrucciones Par El Montaje Y El Funcionamiento

The pressure loss of the GS Pro-Fi
filter insert used can be found in the diagram:
NOTICE ON THE FILTER INSERT
There is no such thing as a universal filter insert. The filter insert should be selected
based on the specifications of the burner manufacturer according to filter mesh and
the present operating conditions. According to the recommendation of the IWO Institut
für Wärme- und Öltechnik e.V, filter inserts made of sintered plastic materials with a
mesh width of 30-75μm should be used. Regarding oil systems with so-called
"Low-NOx burners" and burners with lower heat outputs, the GOK filter inserts
FEINFILTERUNG (fine filtration) with a mesh width of < 35μm are recommended.

ASSEMBLY

Before assembly, check that the product is complete and has not suffered any damage during
transport.
Installation, maintenance and start-up may only be carried out by companies that are
specialist companies for this work in terms of Section 3 of the German Ordinance on
Facilities Handling Substances Hazardous to Water (VAwS) from 31 March 2010 (Federal
Law Gazette, P. 377).
Connection assembly
6 / 16
Combined heating oil filter breather type GS Pro-Fi
®
3 depending on the fuel oil volume flow rate and the
:
Female thread G 3/8 acc. to EN ISO 228-1, as
screw-in opening G 3/8-UA-O acc. to
prEN 12514-4:2009 Figure D.1
O-ring dimensions 14x2 mm, included with
delivery
Screw-in connectors, type B acc. to EN ISO 1179-
4 or prEN 12514-4 Annex C (adequate with type A
acc. to DIN 3852-2)
The recommended maximum torque with steel
screw-in connector is 15 Nm
®
3
Item No. 13 512 53