Flexible Pipe Assembly - GOK GS Pro-Fi 3 Instrucciones Par El Montaje Y El Funcionamiento

Universal connection set (UA):
More information about Universal connection fitting type UA can be found at
www.gok-online.de/de/downloads/technische-dokumentation.
More information about compression fittings can be found at
www.gok-online.de/en/downloads/technical-documentation/Assembly
instructions - Compression fittings.
Installation position and mounting
Installation position vertical as a matter of principle,
• filter tray with filter insert
• vent tray at the top.
®
The GS Pro-Fi 3 is delivered with pre-mounted holding plate
mounted on both sides of the housing.
• Pull down the holding plate, remove the holding plate, suspend it with the screws on the
opposite side of the housing, and push it upwards.
The specialised company and the operator must observe, comply with and understand all of
the following instructions in this assembly and operating manual. For the system to function
as intended, it must be installed professionally in compliance with the technical rules
applicable to the planning, construction and operation of the entire system.
Item No. 13 512 53
Combined heating oil filter breather type GS Pro-Fi
The female thread can also take the GOK universal
connection set type UA, which corresponds to a
compression joint type G acc. to prEN 12514-4:2009
Annex D.
Piping used:
Copper pipe with outer diameter 6, 8 or 10 mm, e.g.
acc. to EN 1057
The housing is made from a zinc die-cast alloy:
Do not use a conical pipe thread acc. to EN 10226-1.

Flexible pipe assembly

The following connections may be used in addition for
flexible oil lines and their pendant:
• cap nut G 3/8 with inside taper 60° pursuant to
prEN 12514-4 Appendix B
A reinforcement ring must be used with all thin-walled
pipes and with soft pipe materials.
Brass reinforcement rings may not come into contact with aluminium
pipe. Risk of corrosion!
at the bottom
for wall assembly. It can be
®
3
7 / 16