Connect To An External Audio Device - Maxell MXSB-252BT Manual De Instrucciones

Connections
Using RCA IN socket
For audio devices that do not offer an
Optical output, please follow the set up
below.
a) Connect Composite Video output of
the AV equipment e.g. DVD recorder
to Composite Video input on the TV.
b) Connect Audio L-R output of the AV
equipment to the LINE IN or RCA input
onto the unit.
Using Line-IN socket
You can listen to the sound of the TV program by
connecting to the Soundbar via
LINE-IN cable.
Note:
You can also connect to your PC with
LINE-IN cable in the setup shown below.

Connect to an External Audio Device

You can connect to your audio devices,
e.g. CD player, to enjoy purely music, via
the following connections.
Audio Equipment, e.g. CD player, MP3 player
This unit features an auto - on/off function,
(RCA/LINE-IN inputs only).
When there is no input (or sound) detected
by the Soundbar for a couple of minutes the
Soundbar automatically goes into standby mode.
When the input has been restored, the Soundbar
will automatically turn on after a few seconds.
Warning:
If the volume of the TV or an external device via
RCA or LINE IN is too low, the auto-off function will
be triggered. When this situation occurs for 2.5
minutes, LED source light will flash slowly on the
unit for the next 30 seconds, after which the unit
will switch to standby mode. Please turn up the
volume of the input source (e.g. TV or MP3 player,
etc. not the Soundbar) slowly, until it returns to
normal mode.
To avoid the auto-off being triggered
unintentionally, pre-set the source volume higher
and adjust the Soundbar volume to a
comfortable level.
Note:
You might hear the sound over-lapping from both
the TV and the Soundbar while following some of
the suggested connections. To avoid this, turn the
volume of the TV down to 0 (zero) or mute it.
EN-9