Whole House Water Filter Tank Installation - Enviro NaturSoft Pro Serie Manual Del Proprietário

Enviro Water Products Pro Series Water Filter and
Salt-Free NaturSoft System
®

Whole House Water Filter Tank Installation

1. Level the Enviro Water Products Whole House Water Filter.
Figure 7
2. Determine the size and material of your incoming water supply line from the Sediment Filter System and
choose the appropriate plumbing required to adapt to the 1" Male NPT Assembly.
CAUTION:
Do not over-tighten any of the fittings during installation.
Table 2: Bypass Valve Fittings
Note: The fitting below is designed with a ¼
is intended to have some flexibility.
Part Description
1" Plastic Male NPT Assembly:
V3007-04 WS1 Fitting 1" Plastic Male NPT
Assembly (2): O-Rings (2), Split Rings
(2), and Connectors (2)
3. Install the fitting onto the inlet and outlet sides of the Bypass Valve. Follow the diagram supplied
with the fitting.
4. Connect the incoming water supply from the Pre-Filter System to the fitting on the inlet side of
the Bypass Valve.
5. Connect the outgoing water supply to the oultet side of the Bypass Valve.
© 2014 Enviro Water Solutions LLC
3060 Performance Circle, Suite 2. DeLand, FL 32724
Incoming
Water
Supply
Whole House
Water Filter
give to allow for proper pipe alignment. It will not leak and
"
Qty.
Split Ring
1
bag
PVC Fitting*
Outgoing
W ater to
House
1" NPT Assembly
Bypass Valve
*Customer supplied,
choose appropriate connection
Quick Connect Nut
O-Ring
www.envirowaterproducts.com
Rev C
Page 10