Enviro Water Products Pro Series Water Filter and
Salt-Free NaturSoft
System
®
Maintenance
Premium Whole House Water Filter
Your Enviro Water Products Premium Whole House Water Filter requires care and cleaning after a period of
5 years. Replacement media and instructions can be ordered by contacting your local authorized Enviro
Water Products dealer.
Sediment Filter
It is recommended that the Sediment Filter be replaced every 6-9 months depending on the amount of
sediment present in the water supply. If the system has been working properly and the pressure is
slowing, it may be time to change the Sediment Filter. Check the Sediment Filter and replace if necessary.
Replacing the Sediment Filter
Sediment Filter Cover
Blue Sediment Filter Housing
1. Turn off the main water supply to the System and bypass all tanks.
2. Run a faucet (cold water) inside the house to relieve the pressure. (Leave faucet open)
3. Unscrew the Blue Filter Housing clockwise using the supplied Filter Wrench.
4. Remove the existing Sediment Filter and discard.
5. Remove & discard the O-Ring and wipe the groove clean. Lubricate a new O-Ring with a coating of
clean food grade silicone grease. Replace O-Ring and press the O-Ring down into the groove.
Note: This step is important to ensure the proper filter seal. Make sure the O-Ring is seated level
in the groove. If the O-Ring appears damaged, stretched, or crimped it should be replaced.
6. Place a new Sediment Filter onto the Stand Pipe in the Blue Filter Housing.
7. Screw the Blue Filter Housing onto the Cover hand tight. Lightly snug the housing with the
wrench making sure not to over-tighten.
8. Turn on main water supply slowly to allow the Filter System to fill with water and expel air from
lines through open faucet. Put tanks back in service, out of bypass.
9. Check for leaks
© 2014 Enviro Water Solutions LLC
3060 Performance Circle, Suite 2. DeLand, FL 32724
Page 17
Sediment Filter
O-Ring
Stand Pipe
www.envirowaterproducts.com
Rev C