Product Operation And Specifications; Water Conditions For Operation - Natursoft ® Pro Systems - Enviro NaturSoft Pro Serie Manual Del Proprietário

Enviro Water Products Pro Series Water Filter and
Salt-Free NaturSoft System
®

Product Operation and Specifications

Specification Description
Service Flow
Peak Flow
Minimum Working Pressure
Maximum Working Pressure
Maximum Vacuum
Operating Temperatures
pH Range
Water Conditions For Operation - Pro Natursoft Systems
The water should be free of hydrogen sulfide, a dissolved gas with a characteristic smell of rotten

eggs. If present, it can coat the catalytic surface of the media and interfere with the process. The gas
should be removed through adequate pre-treatment.
The water should be free of hydrocarbons, oils, and lubricants. If present, they can coat the catalytic

surface of the media and interfere with the process. Remove through adequate pre-treatment.
The water should contain less than 1 mg/l of phosphates. Phosphates sequester dissolved hardness

molecules preventing them from forming crystals and may coat the catalytic media surface and
interfere with the process.
The copper level in the water supply should be below the MCL of 1.3mg/L. If copper is present above

this level, it can attach to the surface of the catalytic media and interfere with the process.
WARNING:
If this or any other system is installed in a metal (conductive) plumbing system, i.e. copper or
galvanized metal, the plastic components of the system will interrupt the continuity of the
plumbing system. As a result any errant electricity from improperly grounded appliances
downstream or potential galvanic activity in the plumbing system can no longer ground
through contiguous metal plumbing. Some homes may have been built in accordance with
building codes, which actually encouraged the grounding of electrical appliances through the
plumbing system. Consequently, the installation of a bypass consisting of the same material
as the existing plumbing, or a grounded "jumper wire" bridging the equipment and re-
establishing the contiguous conductive nature of the plumbing system must be installed prior
to your system's use.
CAUTION:
When adding a filtration/Conditioning system to homes/buildings supplied by well water, the system
should be installed following the pressure tank. DO NOT USE this system for pneumatic or hydro
pneumatic applications. If you are using a booster pump, then install this system following
the booster pump. If you have questions, please call customer service.
© 2014 Enviro Water Solutions LLC
3060 Performance Circle, Suite 2. DeLand, FL 32724
Pro Carbon 1044 Pro Carbon 1344
7 GPM 10 GPM
10 GPM 13 GPM
25 PSI
80 PSI
5 inch/127 mm Hg
36°F - 120°F
7 - 11
Pro NaturSoft ®
10 GPM
14 GPM
www.envirowaterproducts.com
Rev C
Page 4
844