Audiovox Prestige P-94 Manual Del Propietário página 3

3
SELECT BUTTON (SEL)
DISPLAY CALL
DISPLAY PRIORITY SELECTOR
IGNITION-OFF CLOCK CALL
This button is used to select the audio function (volume, bass,
treble, balance, or fade) to be adjusted using the Level Control
2
, as well as the indication (time, frequency, or CD) shown on
the display panel.
During radio operation, a momentary press of the button will
change the display from frequency to clock time. Another press
of the button will change to station pre-set number (if the selected
frequency is one of the 6 pre-set stations on the band in use).
After 5 seconds, the display will automatically return to frequency
if set to frequency/CD display priority. If the unit has been set to
time display priority, momentary presses of the button will change
the display from time to frequency/CD track number and then
pre-set number/CD elapsed time. After 5 seconds, it will change
back to time display.
During CD operation, a momentary press of the button will
change the display from track number to clock time. Another
press of the button will change to CD elapsed time. After 5
seconds, the display will automatically return to track number if
set to CD track display priority. If the unit has been set to time
display priority, momentary presses of the button will change the
display to CD track number and then CD elapsed time. After 5
seconds, it will change back to time display. If the unit has been
set to elapsed time priority, momentary presses of the button will
change the display to clock time and then CD track number.
Additional momentary presses of the button will set the unit for
bass adjustment (level number above "BASS" will flash on
display panel), treble (level number above "TREBLE" will flash),
balance ("bAL" on display), fader ("FAd") or volume (level
number). The display will automatically return to the normal
indication 5 seconds after the last adjustment is made or when
another function is activated.
This unit can be set so that either the clock time or radio
frequency/CD function will normally appear on the display panel.
Use the following procedure to set the display priority:
CLOCK TIME PRIORITY: With radio frequency on the display
panel, press and hold the Select button for approximately 2
seconds until clock time is shown.
automatically return to time display 5 seconds after any other
radio, CD or audio function display.
NOTE: Release the button as soon as the display changes from
frequency to time (approximately 2 seconds). Holding
the button in for too long will put the unit into time setting
mode (flashing time display). See section on "Setting the
Clock".
FREQUENCY/CD TRACK PRIORITY: With clock time showing
on the display panel, press and hold the Select button for
approximately 2 seconds until the frequency display is shown.
The display will now automatically return to radio frequency or CD
track 5 seconds after any other function is activated.
CD ELAPSED TIME PRIORITY: During CD play mode, press
and hold the Select button for approximately 2 seconds until the
elapsed time display is shown. The display will now automatically
return to elapsed time 5 seconds after any other function is
activated.
-2-
The display will now