Audiovox Prestige P-94 Manual Del Propietário página 5

8
AM/FM BAND SELECTOR
AUTO-STORE TUNING (AS)
SCAN TUNING (SCAN)
RADIO/CD MODE SELECTOR (MODE)
During radio operation, each momentary press of this button will
change the radio band. The indication "AM", "FMI", "FMII" will
appear on the display panel according to your selection.
Pressing and holding the button for 0.5 seconds will activate the
Scan Tuning function which will scan the stations on the band in
use. The unit will stop at each station for 10 seconds before
continuing to the next station (the frequency on the display panel
will flash during Scan operation).
momentarily to stop Scan operation and remain on the selected
frequency.
Pressing and holding the button for longer than 4 seconds will
activate the Auto-Store Tuning function which will automatically
scan the AM or FM band in use and enter strong stations into the
pre-set memory positions for that band. If you have already set
the pre-set memories on the AM or FM band to your favorite
stations, activating the Auto-Store feature will erase those
stations and enter new ones. This feature is most useful when
traveling in a new area where you are not familiar with the local
stations.
During disc play, pressing this button will stop play of the disc and
switch to radio operation without ejecting the disc. During this
time, the DISC IN indication will remain on the display panel to
show that a disc is still loaded in the unit. Pressing the button
additional times will change the radio band as well as return to
disc play from the point at which it was stopped.
9
Each time the + side of the button is tapped, the radio will tune one
frequency step higher. Similarly, each tap of the – side of the
button will tune one frequency step lower. To manually tune in a
station, tap the button of the appropriate direction until the
desired frequency is reached.
Pressing either side of the button for longer than 0.5 seconds and
then releasing will activate the Automatic Seek Tuning function in
the selected direction. The radio will seek the next available
station and stop at that frequency. The Seek function can be
stopped by pressing the button again or activating any other
Press the button again
tuning function.
Pressing either side of the button for longer than 0.5 seconds will
cause the radio to continue tuning rapidly in the selected direction
until the button is released at which point it will seek to the next
available station.
bl
To set any of the 6 pre-set memories in each band, use the
following procedure:
1. Turn the radio on and select the desired band.
2. Select the first station to be pre-set using the Manual Up/Down
3. Press the pre-set button to be set and continue to hold it in.
4. Repeat the above procedure for the remaining 5 pre-sets on
-4-
MANUAL UP/DOWN TUNING (TUN+ / TUN–)
AUTOMATIC SEEK TUNING
STATION PRE-SET MEMORIES
or Automatic Seek Tuning Controls
After approximately 2 seconds, the display will flash and the
volume will be momentarily muted indicating that the station is
now set into that pre-set memory position. The station can
now be recalled at any time by pressing that button.
that band and for the other 3 bands on the unit.
9
.