Machine Information; Technical Specifications - VONROC HT501DC Traducción Del Manual Original

ADDITIONAL SAFETY WARNINGS FOR
CORDLESS HEDGE TRIMMER
• Do not charge hedge trimmer in rain, or in wet
locations.
• Do not use battery-operated hedge trimmer in
rain.
• Remove or disconnect battery before servicing,
cleaning, or removing material from the hedge
trimmer.
• Do not dispose of the battery(ies) in a fire. The
cell may explode. Check with local codes for
possible special disposal instructions.

2. MACHINE INFORMATION

Intended use
This hedge trimmer is only intended for cutting
branches from shrubs, bushes, ornamental plants
and hedges.

TECHNICAL SPECIFICATIONS

Model No.
Rated voltage
No load speed
Cutting length
Cutting width
Weight
Sound pressure level L
PA
Sound power level L
WA
Vibration value
Only use the following batteries of the VONROC VPO-
WER 20V battery platform. Using any other batteries
could cause serious injury or damage the tool.
CD801AA 20V, 2Ah Lithium-Ion
CD803AA 20V, 4Ah Lithium-Ion
The following charger of the can be used to charge
these batteries.
CD802AA Quick charger
The batteries of the VONROC VPOWER 20V battery
platform are interchangeable with all the VONROC
VPOWER 20V battery platform tools.
Vibration level
The vibration emission level stated in this instruc-
tion manual has been measured in accordance
WWW.VONROC.COM
HT501DC
20V
1.400/min.
510mm
14mm
2.15 kg
79.1 dB (A), KpA=3 dB (A)
90.1 dB (A), KwA=3 dB (A)
1.937 m/s K=1.5 m/s
2 2
with a standardized test given in EN60745; it may
be used to compare one tool with another and as
a preliminary assessment of exposure to vibration
when using the tool for the applications mentioned.
• Using the tool for different applications, or with
different or poorly maintained accessories, may
significantly increase the exposure level.
• The times when the tool is switched off or when
it is running but not actually doing the job, may
significantly reduce the exposure level.
Protect yourself against the effects of vibration by
maintaining the tool and its accessories, keeping
your hands warm, and organizing your work patterns.
DESCRIPTION
The numbers in the text refer to the diagrams on
page 2-3.
1. On/Off button
2. Battery (not included)
3. Battery unlock button
4. Cutting blade
5. Protection guard
6. Front handle
7. Safety switch
8. Transport protection
3. ASSEMBLY
Before any work on the power tool, remove
the battery.
The battery must be charged before first
use.
Mounting the front handle (Fig. B)
1. Put the front handle (6) on the machine, as
shown on figure B.
2. Mount the front handle (6) by tightening the
four screws.
Mounting the protection guard (Fig. C)
You may not use the hedge trimmer without
the protection guard
1. Put the protection guard (5) on the machine, as
shown on figure C.
2. Mount the protection guard (5) by tightening
the two screws.
EN
7