Autoadapt Turny Evo Manual De Instalación página 30

30
Turny Evo Getting seated
2
Place the application tool in the car and centre it above OEM seat attachment in the floor.
Then adjust the L-profile brackets laterally. The distance between L-profile bracket and cen-
tre of OEM seat attachment must be between 15-45 mm in order that the installation will
be stable. A distance of at least 15 mm at the same time ensures that the head of the screw
will not take in the rounding of the bent leg when installing. By using the application tool
ensure that there is sufficient space for Turny Evo movement paths. When required the
L-profile bracket closest to the door can be laterally inverse to achieve an optimal position.
The L-profile bracket closest to the transmission tunnel may not be turned round because it
will then end up within Turny Evo's crash segment.
Strive to place the L-profile brackets as parallel with each other as possible. This may mean
that OEM seat attachment ends up on both sides of the L-profile bracket which is a correct
alternative solution.
This part of the application tool lie against the B
pillar to ensure that Turny Evo has the best possible
swivelling space.
OEM
The L-profile bracket closest to the door be laterally
inverse when required as the illustration to the right
shows. The specified distance measurements apply
to all seat attachments no matter how the side of
the L-profile bracket is placed.
OEM
15 - 45 mm
OEM