Symbols; Protection Class; Description Of The Appliance; Preparation - Imetec F2015 Instrucciones De Uso

Protection class II
EN
Carefully read the instruction
manual
Warning
Temperature selector
Off position
Do not insert pins or needles
Wash at 40°C max with a delicate
cycle
Drying in tumble dryer with program at
moderate temperature
Do not insert pins or needles
Refer to the Illustrative guide on page to verify your appliance equipment.
1. Throw connector
2. Control connector
3. Mains socket
4. Label
• Insert the control connector Fig. [A] (2) in the throw connector (1) to connect the control unit to the
throw.
• Plug the control connector in the mains socket Fig. [B] (3).
• Spread the throw over the sofa, ensuring that the throw connector is at the foot position.
• Your bi-colored throw can be used both with the connector facing downwards or upwards at your
choice.
• When using the throw on a chair, sofa or bed, place it over you to keep you warm and cosy, but do
not wrap it tightly or sit on it as this may cause the overheat protection system to activate.
• Do not fold or bend the wired areas, as these actions could result in activating the over heat
protection system
WARNING! DO NOT use this appliance if there are visible
signs of damage.
WARNING! NOT suitable for children under the age of 3.
12

SYMBOLS

DESCRIPTION OF THE APPLIANCE

5. Temperature display
6. Timer selector
7. Express fast pre-heat button
8. Temperature selector

PREPARATION

Prohibited
Important note
Not suitable for children under
the age of 3
Standby selector
On position
Fast heat
Do not bleach
Do not dry-clean

USE

9. Stand-by display
10. Auto shut off display
11. On/off switch