Tabla de contenido
Publicidad
SECTION 5:
MAINTENANCE AND TROUBLESHOOTING
5.1 Maintenan
The only routine m
with frequency bein
MAINTENANCE SCHEDULE
Maintain more often if used under extremely dusty or severe
EACH USE: Visual inspecti
WEEKLY: Visual inspection of torch body, consumables, cables, and leads
Replace or repair as needed.
3 MONTHS: Clean exterior of power supply. Clean and tighten weld terminals.
6 MONTHS: Blow out or vacuum and accumulated dust/dirt from the interior.
5.2 Troubleshooting
If you are experiencing trouble with your unit, please refer to the following table
for assistance. If you are experiencing issues that are not addressed in the
following please contact Smarter Tools Customer Service for help in resolving
your issue.
ce
aintenance required is a thorough cleaning and inspection,
g dependent upon the usage and the operating environment.
THIS PRODUCT CONT
VOLTAGES. TURN OFF THE POWER SWITCH, UNPLUG
THE POWER CABLE FROM THE OUTLET, AND ALLOW
AT LEAST 2 MINUTES FOR THE PRIMARY CAPACITORS
TO DISCHARGE BEFORE PERFORMING MAINTENANCE
OR ATTEMPTING TO OPEN THE ENCLOSURE.
To clean the unit, open the enclosure and use a vacuum
cleaner or blow gun to remove any accumulated dirt and dust.
Avoid direct contact with electrical boards. Ensure that all fans
and exhaust vents are clean and clear.
The unit should also be wiped clean, if necessary; with solvents
that are recommended for cleaning electrical appliances.
on of regulator, pressure, and consumable parts.
AINS EXREMELY DANGEROUS
5‐1
conditions.
.
Publicidad
Tabla de contenido
Solución de problemas
