D-Link DCS-80-5 Guía De Instalación Rápida página 4

Installation
Step 1: Obtain the 22-pin data cable from the
camera packaging.
Step 2: Identify the 3-pin AC 24 V connector
(red/yellow/black). Cut the wires.
Step 3: Identify the BNC video out connector.
Cut the wire.
NOTE: This analog video output is not required
for installation and can safely be removed.
Step 4: Remove wire shielding of from the AC
24 V cables with a wire stripper. Expose 3 mm
of naked wire.
4  D-Link DCS-80-5/6 Outdoor Power Box 4  D-Link DCS-80-5/6 Outdoor Power Box
Step 5: Thread the 22-pin data cable through
the C2 or C4 port of the Power Box. Be sure to
pull all wires through completely.
Step 6: Connect the AC 24 V cables to the
power terminal block (J2).
Step 7: Make sure the AC 24 V cables are in
the right order.
Pin 1
Red Yellow
Table 6. Pin/Wiring Definitions
Step 8: Secure the brass pillar to the circuit
board.
Pin 2 Pin 3
Black