Polygroup SUMMER WAVES RP350 El Manual Del Propietario página 16

5. Please see Pool Support - Filtration System Troubleshooting for the RP350/RP400 Filtration System at support.polygroupstore.com.
PLEASE NOTE: Even if the rotor assembly is in perfect condition; if it is not seated properly between the volute housing and the pump it will not function correctly.
6. To reassemble the pump (Motor Assembly): Carefully insert the Rotor Assembly
assembly into the pump. Ensure that the Rotor Assembly is completely assembled and aligned correctly inside the pump body.
7. Once the rotor has been inserted, fasten the volute housing tabs back under the brackets of pump body by turning the volute housing discharge nozzle clockwise.
8. Tighten the Volute Housing
s
9. Slowly insert the Motor Assembly
Shaft End Cap
Washer
Impeller
Magnet Axle
Rotor Shaft
(This shaft should go through
all the parts and into both
Shaft End Caps)
Washer
Shaft End Cap
16
With the Volute Cover Screw Set
d
back into the Canister , and fasten the Motor Assembly
i u
Rotor Assembly
into the Pump Motor Body
a
to complete the reassembly of the pump (Motor Assembly).
With Motor Assembly Washer and Screw Set
i
22
20
pump body
. The force of the magnet will pull the rotor
p
Volute Housing Screws
21
Volute Hosing
Discharge Nozzle
Slide the tabs of Volute Housing
underneath the brackets of
Pump Body to lock
Brackets on pump body
19
.
h