Revert To Factory Settings; Personalization; Screen Configuration - SCUBAPRO UWATEC Galileo Luna Manual Del Usuario

2.8.7 Revert to factory settings

This menu allows you to revert all settings
in all menus of the computer back to the
original factory settings. In order to do this,
you need to enter the safety code (313).
This prevents unintentionally reverting all
settings. To enter the code, use the "+"
and "–" buttons to define the first digit (3),
then press ">>" to confirm it. Now define
the next digit (1), confirm by pressing
">>" then define the last digit (3). Upon
pressing "SaVe" after having defined the
last digit, a setup routine is initiated. This
allows you to choose the language, units
and time zone after which all settings will be
reverted to the original factory defaults. The
display shows the message reVert to
factory SettinGS SucceSSfuL for
2 seconds.
F
NOTE:
Reverting to factory settings does
not cancel existing transmitter pairing
information nor does it cancel owner
and emergency information.
2. Menus, settings and functions
2.9

Personalization

(patents pending)

2.9.1 Screen configuration

(default: CLASSIC WITH GRID)
In this menu you can set your preferred
display layout, as described in Chapter 1.
You can choose between cLaSSic,
cLaSSic WitH Grid, LiGHt and fuLL
configurations. You can also rotate the
display by 180 degrees, so that the buttons
are at the bottom of the computer.
F
NOTE:
- The LIGHT configuration does
not support
stops or decompression stops.
If you have chosen the LIGHT
configuration and you enter level
stops or decompression,
screen configuration will switch to
CLASSIC until you have fulfilled
all level stop and/or deco stop
obligations.
dives with level
the
35