Remote Control Programming - Vimar SW24.T Guía Rápida Para El Instalador

SW24.T

Remote control programming

Note: remote control programming can only be done with the automatic gate system stationary
Step-by-step programming
No. Pressing push button
1 MRX
Remote control push-
2
button
3 -
Programming the second radio channel
No. Pressing push button
1 MRX
Remote control push-
2
button
3 -
Deleting a remote control
No. Pressing push button
1 MRX
Remote control push-
2
button
3 -
Complete deletion of the receiver
No. Pressing push button
1 -
2 MRX
3 -
Note:after deleting all the remote controls, the first saved remote control configures the control panel to accept only remote controls with a
rolling code or only remote controls with a fixed code.
Signal PRG LED Description
Off Press the MRX push-button and hold it down until the green PRG LED starts flashing slowly
Slow blink Press the remote control push-button that you want to save
Fixed 1 s Button of the saved remote control (new remote control)
3 blinks Memory full
Signal PRG LED Description
Off Press the MRX push-button and hold it down until the green PRG LED starts flashing fast
Fast blink Press the remote control push-button that you want to save
Fixed 1 s Button of the saved remote control (new remote control)
3 blinks Memory full
Signal PRG LED Description
Press the MRX push-button and hold it down until the green PRG LED starts flashing very
Off
fast
Very fast flashing Press the button on the remote control to delete
Fixed 1 s Deletion successful
Signal PRG LED Description
Off Remove power from the control panel and disconnect any batteries
Reapply power to the control panel without releasing the MRX button until the PRG LED
On steady
turns off
Off Receiver deleted completely
EN
9