OPERATING THE UNIT
Reading the memory
If the device has been switched off, press the save button "MEM" (C) and the last 3 average
measured values will be shown on the display. The last measured values are shown by pressing
the save button "MEM" (C) once more. At every press, the memory moves to the older measured
value.
Deletion of the memory
If you are sure that you want to delete all the saved measured values of the chosen user, press
the "SET button (B) 8 times until CL appears in the display. The device now switches itself off.
Now press the START / STOP button (A) and CL will flash 3 times in order to delete all saved
measurement results. Now press the save button "MEM" (C) and M and "no" will be shown on
DE
the display. This means that there are no measurement results in the memory
SAFETY INSTRUCTIONS
EN
FR
Special warnings!
•
People with arrhythmia, diabetes, circulatory disorders or apoplexy problems must only use
the device under medial supervision.
•
Contact your doctor for specific information on your blood pressure. Self-diagnosis and
IT
self-treatment based on the measurement results can be dangerous. Always follow the in-
structions of your doctor.
•
It is not permitted to make changes to this device.
ES
•
Do not change anything on this device without the manufacturer's approval.
•
If this device has been changed, an appropriate inspection and check must be carried out
in order to ensure that the device can be safely used.
NL
•
Do not use a mobile phone close to the device. This can lead to failure of the device.
•
Please avoid proximity to radiating surfaces, in order to avoid distortion of the measure-
ments.
RU
•
Never place the arm cuff tube around the neck as this can lead to choking.
•
Only use approved arm cuffs, because otherwise the correct functioning of the device can-
not be guaranteed.
PL
Pay attention to the following before first time operation:
•
Only for home use.
•
Scrupulous supervision is required when the device is being used in the vicinity of children.
SE
•
Never place or use the unit in a wet or moist environment.
•
Do not use the unit under water, e.g., under the shower.
•
Never place the unit in direct contact with fire, gas or oxygen, or hot objects such as hot
FI
plates.
26