Type plates are located on the power unit housing, on the telescopic columns,
and on the underside of the desktop.
3. Intended use
Intended use also includes following all instructions in the user manual.
The Migration SE is designed exclusively to be used as office furniture for commercial purposes. Any
other use, or use beyond the specified intended use is considered to be improper use. Improper use of
the product can result in dangers to life and limb as well as property damage. For this reason, improper
use is prohibited. In case of improper use, Steelcase assumes no liability for any damage that may occur
and does not guarantee that the components will function properly. Possible improper use includes:
Use for the lifting of loads
■
Use as a climbing aid
■
Use as a permanent storage surface for
■
objects with a total weight of more than 75
kg.
4. Height adjustment
Optimum desk height
Adjustment to the optimum desk height (sitting height) is crucial for the
correct sitting posture at the workstation. The correct desk height setting for
the workstation can be found in the workstation analysis (pursuant to the
German Occupational Safety and Health Act, the German VDU Ordinance, or
EN
accident prevention regulations, for example). See also BGI 650: Screen and
office workstations. Design guidelines.
4.1 Lift 1 variant
ATTENTION
Before first use make sure that
the desk has been assembled correctly;
■
the controller is connected to the motor by cable;
■
the control panel is connected to the controller;
■
all safety-relevant information has been followed.
■
It is necessary to perform a manual reset before first use, see User Guide
(steelcase.de) or
4.1.1 Height adjustment (up/down) via control panel
Press the respective "Up / Down" button to reach the desired desk height.
The desktop is moved up or down until the buttons are released or until the minimum / maximum
height has been reached.
145521
5.3 Manual reset of desk
Outdoor use
■
Use in damp rooms
■
.
Migration SE
Rev. C