Steelcase Migration SE Desk Guía Rápida página 6

5.3 Manual desk reset
 Press and hold the "Down" button until the lower end position (programmed desktop position) is
reached.
 Release the "Down" button
 Again, press and hold the "Down" button for approx. 8 seconds.
The desktop moves to the lower end position.
 Release the "Down" button. The system is now ready for operation.
5.4 Switching the indicated unit (cm/inch) (Memory control panel)
 Press the buttons 1, 2 and "Up" at the same time and hold for three seconds; then release the
buttons.
S and a number (e.g. S 7) are indicated on the display.
 Press and hold the "Up" button until S 5 is indicated on the display.
S 5 is indicated on the display.
 Press the save button.
If the display was previously set to centimetres (cm), it will now be switched over to inches (inch)
and vice versa.
EN
5.5 Resetting to factory settings (Memory control panel)
This function can be used to reset the DM-system to its factory settings.

Press and hold the buttons shown below for 3 sec.:
a Press buttons "1" and "2" and the
b "Up" button
The letter S and a number (e.g. S 4) are shown on the display

Press the "Down" button until S 0 is shown on the display.
The display indicates: S 0

Press the "SAFE" button.
The DM-system has been reset to its factory settings. A manual desktop reset may be required.
145521
Migration SE
Rev. C