Publicidad
Idiomas disponibles
Idiomas disponibles
4
To Adjust Saw Chain Tension.
9.
Turn saw chain tensioner screw (P) (located next to guide bar)
clockwise to tighten saw chain on guide bar. Turning screw
counter clockwise will loosen saw chain on guide bar.
10.
Tighten guide bar nuts (C) firmly. Move saw chain backwards on
guide bar by hand. Saw chain should move freely on guide bar if
it is in proper mesh with sprocket.
Keep the saw chain lubricated and properly adjusted and the guide bar
nuts tightened firmly at all times. If saw chain is difficult to rotate or
binds on guide bar, it is too tight.
ADJUSTING AUTOMATIC OILER
1.
Remove two (2) 10 mm (13/32 in.) guide bar retaining nuts (C) and
sprocket cover.
2.
From bottom of gear case, turn adjustment screw (Q) clockwise to
decrease oil volume - counter clockwise to increase oil volume.
3.
Install guide bar cover and secure with two (2) guide bar retaining
nuts (C).
NOTE
Very little visible oil on the saw chain will provide sufficient
lubrication.
E
, I
CHO
NCORPORATED
400 O
R
AKWOOD
OAD
L
Z
, IL 60047
AKE
URICH
C
P
Q
Publicidad
