General Specifications - Klein Tools PROBEplus Manual De Instrucciones

ENGLISH
The Klein Tools PROBEplus is a professional series tone tracer for wire
tracing and cable identification. It features digital volume control and a loud
built-in speaker to assist you in tracing and identifying wire.
• Tap power button to toggle on/off: continuously holding down the
power button is optional.
• Hold on/off button to power on; release to power off.
• Digital volume control.
• Tone detection LED.
• Amplifier overload LED.
• Low Battery Indication.
• Replaceable tip (VDV999-065, sold separately).
• Lanyard attachment loop.
• Dimensions:
6.0 oz. (170 grams) with battery
• Weight:
• operating Temperature:
• Storage Temperature:
• Humidity: 10% to 90%, non-condensing
• Altitude: 10,000 feet (3,000 meters) maximum
• Battery Life: 9V alkaline battery - typical
• Standby:
• Active:
To ensure safe operation and service of the instruments, follow these
instructions. Failure to observe these warnings can result in severe injury
or death.
• The PROBEplus is designed for use on extra low voltage cabling
systems (less than 60 volts).
• These instruments are not designed to be used outdoors.
• Do not use instruments if they are wet, as this could pose a shock hazard.
• Turn off PROBEplus before attempting to replace batteries.
• Do not use PROBEplus if it is damaged in any way.
SYMBOLS:
Warning: Potential for personal injury.
Caution: Potential for damage or destruction to equipment.
Always wear approved eye protection.
Do NOT use on energized circuits.
Conformité Européenne. Conforms with European
Economic Area directives.
This symbol indicates that equipment and its accessories
shall be subject to a separate collection and correct disposal.
2
PROBEplus
Instruction Manual
FEATURES

GENERAL SpEcIFIcATIoNS

9.85" x 2.00" x 1.14" (25.02 x 5.08 x 2.90 cm)
0°C / 32°F to 50°C / 122°F
-20°C / -4°F to 60°C / 140°F
4 years
25 hours
WARNINGS