Venting The Dryer; Important - Kenmore 796.8128 Manual De Uso

VENTING THE DRYER
IMPORTANT!
CHECK YOUR EXHAUST
SYSTEM FOR PROBLEMS
The most common cause of dryer problems ispoor
exhaust venting.Beforeinstalling your new dryer,
check the items listed below to make sure you get the
best possible performance. This can save you time and
money by reducing cycle times and increasing energy
emciency.
* DIRTY OR DAMAGED EXHAUST DUCTS. Lint builds
up in exhaust ducts over time. This decreases the
airflow and makes the dryer work harder. Visually
inspect your ducts from both ends and have them
cleaned if they have not been cleaned recently.
* WRONG VENT MATERIAL. Check your vent to make
sure it is rigid or semi-rigid metal ducting, if your
venting is plastic or flexible foil, have it replaced
before using the dryer.
* RESTRICTED OR DAMAGED VENT HOOD. Check
your vent hood outside. It must be clean and free of lint
buildup. Check the damper and make sure it opens fully
and easily.
* EXCESSIVELY LONG VENT. Measure the length of your
exhaust system and count the elbows. Use the chart
below to see if your duct is too long. if it is too long,
have the duct routed to another location that is within
the venting guidelines.
*DO NOT USE PLASTIC OR FOIL VENTING. The
transition duct from your dryer to the wall must be rigid
or semi-rigid metal ductJng, if your old transition duct is
plastic or fail, REPLACE iT with semi-rigid metal ducting.
Using the DUCT
LENGTH CHART (below)
Find your vent hood type in the chart below.
Select the row that matches the number of elbows in your dryer duct run.
Look to the right of the elbow number for the maximum duct tength for your installation. Longer duct length will result
in reduced drying performance, longer dry times and increased energy consumption. Extremely long ducts can even
shorten the life of the dryer.
DO NOT exceed the maximum length for the vent hood type and number of elbows used.
Recommended
4"
(10.2 cm)
4"
(10.2 cm)
Only for Short-Run Installations
21/2"
(6.35 cm )
0
]
2
3
4
0
]
65 feet (19.8 m)
55 feet (16.8 m)
47 feet (13.7 m)
36 feet(11.0 m)
28 feet (8.5 m)
55 feet (16.8 m)
47 feet (13.7 m)
2
3
4
41 feet(12.5 m)
30 feet (9.1 m)
22 feet (6.7 m)
NOTE: Deduct 6 ft. (1.8 m) for each additional elbow. Using more than four 90 ° elbows is not recommended.
14