Vollrath Redco InstaCut 3.5 Manual Del Usaurio

Redco
Thank you for purchasing this Vollrath equipment. Before operating the
equipment, read and familiarize yourself with the following operating
and safety instructions. SAVE THESE INSTRUCTIONS FOR FUTURE
REFERENCE. Save the original box and packaging. Use this packaging
to ship the equipment if repairs are needed.
SAFETY PRECAUTIONS
To ensure safe operation, read the following statements and understand
their meaning. This manual contains safety precautions which are
explained below. Please read carefully.
WARNING
Warning is used to indicate the presence of a hazard that will or can
cause severe personal injury or death.
CAUTION
Caution is used to indicate the presence of a hazard that will or can
cause minor or major personal injury if the caution is ignored.
NOTICE: Notice is used to note information that is important but not
hazard-related.
To reduce risk of injury or damage to the equipment
• Check equipment before each use to insure the equipment is clean.
• Check for broken, nicked or dull blades and if found, replace the
blade assembly.
• Check to insure that the pusher head sits down completely on the
rubber bumpers.
• Check to ensure the rubber bumpers are in place. DO NOT USE
EQUIPMENT IF BUMPERS ARE NOT IN PLACE.
• On tabletop models the suction cups will hold the equipment
securely to smooth surfaces.
• Wall mounted equipment must be securely mounted to wall studs.
Use proper size and type hardware to mount equipment to wall.
• If necessary, lubricate guide rods using a light coating of mineral oil,
Petro Gel, or food grade lubricant. DO NOT USE COOKING OIL AS IT
WILL BECOME STICKY AND MAY PERMANENTLY DAMAGE THE
PUSHER HEAD BEARINGS.
FUNCTION AND PURPOSE
Intended for cutting, dicing and wedging vegetables and fruits.
InstaCut 3.5 Tabletop and Wall Mount
® ™
Please register your product at Vollrath.com
©
Operator's Manual
Tabletop Wall Mount
Item No. Item No.
15000 15016
15001 15017
15002 15018
15003 15019
15005 15021
15006 15022
15007 15023
15008 15024
15009 —
15010 15026
UNPACKING THE EQUIPMENT AND INITIAL SETUP
Carefully remove crating or packaging materials from the equipment.
When no longer needed, dispose of all packaging materials in an
environmentally responsible manner.
Installing the wall mounted model
1. Use four (4) ¼" screws of a suitable length to secure the base to the
wall. Install screws into studs. If this is not possible, use proper
anchors and screws to secure base.
2016 The Vollrath Company L.L.C.
Description
¼" Dice
³⁄₈" Dice
½" Dice
4 Section Wedge
6 Section Wedge
8 Section Wedge
10 Section Wedge
12 Section Wedge
6 Section Core
8 Section Core
Part No. 2350022-1 ml 2/26/16