Fasten The Door Bracket; Sectional Doors - Craftsman 139.53925DS Manual Del Propietário

mNSTALLATmON STEP t 2
Fasten the Door Bracket
Follow instructionswhich apply to your door type
as illustrated below or on the following page..
A horizontal reinforcement brace should be long
enough to be secured to two vertical supports. A
vertical reinforcement brace should cover the height
of the top panel.
The illustrationshows one piece of angle iron as the
horizontal brace For the vertical brace, two pieces of
angle iron are used to create a U-shaped support
(Figure 1). The best solution is to check with your garage
door manufacturer for an opener installation door
reinforcement kiL
NOTE: Many vertical brace installations provide for direct
attachment of the clevis pin and door arm, In this case you
will not need the door bracket; proceed to Installation
Step 12.
SECTIONAL DOORS
- Center the door bracket on the previously marked
vertical centerline used for the header bracket
installation, Note correct UP placement, as stamped
inside the bracket (Figure 2).
° Positionthe bracket on the face of the door within the
following limits:
A) The top edge of the bracket 2"-4" (5-10 cm) below
the top edge of the door.
B) The top edge of the bracket directly below any
structural support across the top of the door.,
I
Fiberglass, aluminum or lightweight steel garagedoors WILL I
REQUIRE reinforcementBEFORE installationof door bracket. I
Contactyour door manufacturerfor reinforcementkit, I
1
HARDWARE SHOWN ACTUAL SIZE
Nut 5/16"-18 Lock Washer 5/16"
Cantage Bolt
5/16"-18x2-1/2"
- Mark and drill 5/16" left and right fastening holes,
Secure the bracket as shown in Figure 1 if there is
vertical reinforcement..
If your installationdoesn't require vertical reinforcement
but does need top and bottom fastening holes for the door
bracket, fasten as shown in Figure 2,_
Header Bracket
Horizontal and vertical reinforcement
is needed for lightweight garage doors
(flbergiEass, aluminum, steel, doors with
glass panel, etc), (Not Provided)
Vertical
Centerline
/
Figure t
23