One-Piece Doors - Craftsman 139.53925DS Manual Del Propietário

ONE-PIECE
DOORS
Please read and comply with the warnings and
reinforcement instructions on the previous page,,They
apply to one-piece doors also..
o Center the door bracket on the top of the door, in line
with the header bracket as shown. Mark either the left
and right, or the top and bottom holes,_
• Drill 5/16" pilot holes and fasten the bracket with
hardware supplied,,
If the door has no exposed framing, drill 3/16" pilot holes
and fasten the bracket with 5/16"x1-1/2" lag screws (not
provided) to the top of the door,
NOTE: The door bracket may be installed on the top edge
of the door if required for your installation° (Refer to the
dotted line optional placement drawing,) Drill 3/16" pilot
holes and substitute 5/16"x1-I/2" lag screws (not
provided) to fasten the bracket to the door.
HARDWARE SHOWN ACTUAL SIZE
Nut 51t6"-18 Lock Washer 5/16"
Carriage Boll
5!16"-t8×2_!12"
Header Walt
2x4 Suppod
--F3nfshed Ceiling--
Header
Bracket
Optional
Placement
of Door
Bracke!
Door
Brecke!
Vertical
Centedine of
Garage Door
Horizontal and verlical
reinlorcement is needed for
lightweight garage doors
(tiberglass, aluminum, steel,
door wi_h glass panel, etc )
(not provided}
_Lock
Washer
: 5/I 6'
24