OPERATION
iMPORTANT
SAFETY
iNSTRUCTIONS
To reduce the risk of SEVERE INJURY or DEATH:
1.. READAND FOLLOW ALL WARNINGS AND INSTRUCTIONS_
2. ALWAYSkeepremote controls out of reach of children.
NEVER permit childrento operateor playwith garagedoor
control push buttons or remotecontrols.
3. ONLYactivategaragedoor when it can be seenclearly,it is
properly adjusted,and there are no obstructionsto door
travel.
4 ALWAYSkeepgaragedoor in sight until completelyclosed.
NOONESHOULDCROSS THEPATHOFTHE MOVING
DOOR..
5,. NOONESHOULDGO UNDER A STOPPED, PARTIALLY
OPENED DOOR..
6.. If possible, useemergencyreleasehandleto disengage
trolley ONLYwhen garagedoor is CLOSED. Weak or broken
springs or unbalanceddoor could result in an open door
falling rapidlyand/or unexpectedly..
7, NEVER use emergencyreleasehandleunless garage
doorway is clear of personsand obstructions.
8 NEVER use handleto pull garagedoor open or closed.. I f
rope knot becomesuntied,you could fall.
9o If one control (force or travel limits) is adjusted,the other
control may also need adjustment.
I0 After ANYadjustmentsare made, the safety reversal
systemMUSTbe tested
11. SafetyreversalsystemMUST betested every'month,
Garagedoor MUSTreverseon contact with 1-I/2" high
(3.8 cm) object (or a 2x4 laid flat) on the floor..
12_ ALWAYSKEEPGARAGE DOORPROPERLY BALANCED
(seepage3)._ An improperly balanceddoor may not
reversewhen requiredand could result in SEVERE INJURY
or DEATH.
I3 ALL repairsto cables,spring assembliesand other
hardware,ALL of which are under EXTREME tension,
MUSTbe madeby a traineddoor systemstechnician.
t4. ALWAYSdisconnect electricpower to garagedoor opener
BEFORE making ANY repairsor removingcovers.
I5 SAVETHESEINSTRUCTIONS.
Using
Your
Garage
Door
Opener
Your Security,iP opener and hand-held remote control
have been factory-set to a matching code which changes
with each use, randomly accessing over 100 billion new
codes.,Your opener wili operate with up to eight Security,I _
remote controls and one Security+ ®Keyless Entry System..
If you purchase a new remote, or if you wish to deactivate
any remote, follow the instructions in the Programming
section.,
Activate your opener with any of the following:
• The hand-held Remote ControL:'Hold the large push
button down until the door starts to move.,
o The wall-mounted Door Control:' Hold the push button or
bar down until the door starts to move.
• The Keyless Entry (See Accessories),: If provided with
your garage door opener, it must be programmed before
use° See Programming°
When the opener is activated (with the safety
reversing sensor correctly installed and aligned)
1. If open, the door will close. If closed, it will open..
2_If closing, the door will reverse_
3. if opening, the door will stop.,
4oIf the door has been stopped in a partially open position,
it will close.
5. If obstructed while closing, the door will reverse., tf the
obstruction interrupts the sensor beam, the opener lights
will blink for five seconds.
6. If obstructed while opening, the door will stop,.
7. If fully open, the door will not close when the beam is
broken_The sensor has no effect in the opening cycle..
If the sensor is not installed, or is misatigned, the door
won't close from a hand-held remote, However, you can
close the door with the Door Control, the Outdoor Key
Switch, or Keyless Entry, if you activate them until down
travel is complete,. If you release them too soon, the door
will reverse..
The opener lights will turn on under the fol!owing
conditions: when the opener is initiallyplugged in; when
power is restored after interruption; when the opener is
activated..
They will turn off automatically after 4-1/2 minutes or
provide constant light when the Light feature on the
Premium Control Console is activated.. Bulb size is A19.
Bulb power is 100 watts maximum_
Security+ _ light feature: Lights will also turn on when
someone walks through the open garage door..With a
Premium Control Console, this feature may be turned off
as follows: With the opener lights off, press and hold the
light button for 10 seconds, until the light goes on, then off
again. To restore this feature, start with the opener lights
on, then press and hold the light button for 10 seconds
until the light goes off, then on again.,
3O