Publicidad
Idiomas disponibles
Idiomas disponibles
tool in the battery cover notch to open the battery cover. Install the
9 volt battery by connecting it to the battery boot inside the battery
compartment. Don't yank or pull hard on the battery boot. Replace
the battery cover.
To test that the batteries have been correctly installed, turn on the
wand and the transmitter. LEDs will light on both if the batteries
have been connected correctly. If not, repeat the installation
procedures. In the case of the Pro800D, the battery compartment
is designed to hold the batteries tightly so if you do not get a
signal for power, try adjusting the batteries by rolling them or
moving them forward and backward until the power does come
on.
WARNING – Do not touch the metal red or black alligator
clips on the transmitter cords when the power is on. There is
danger of injury or death should this occur.
Battery Condition LEDs-
There are low battery indicator LED
lights on both the transmitter and receiver. These LEDs light up
when the battery power has been diminished enough to affect the
performance of the Pro800 (about 10 volts in the transmitter, 7
volts in the wand). After the low battery light has come on, the
LED will dim as the available battery power gets weaker. The LED
will not light at all if the battery is completely drained of power.
4
Publicidad
