Craftsman PRO 247.88976 Serie Manual Del Operador página 16

Engaging the Drive
1. With the throttle control in the Fast (rabbit)
into one of the six forward (F) positions or two reverse (R) positions. Select a
speed appropriate for the snow conditions and a pace you're comfortable with.
NOTE: When selecting a Drive Speed, use the slower speeds until you are
comfortable and familiar with the operation of the snow thrower.
2. Squeeze the drive control against the handle and the snow thrower will
move. Release it and drive motion will stop.
NOTE: NEVER reposition the shift lever (change speeds or direction of travel) without
first releasing the drive control and bringing the snow thrower to a complete stop.
Doing so will result in premature wear to the snow thrower's drive system.
Engaging the Auger
To engage the auger and start throwing snow, squeeze the auger control against
the left handle. Release to stop the auger.
Replacing Shear Pins
The augers are secured to the spiral shaft with shear pins (a) and cotter pins (b). If the auger
should strike a foreign object or ice jam, the snow thrower is designed so that the pins may
shear. If the augers will not turn, check to see if the pins have sheared. See Figure 19.
NEVER replace the auger shear pins with anything other than Sears SKU#
88389/OEM Part No. 738-04124A replacement shear pins. Any damage to
the auger gearbox or other components as a result of failing to do so will
NOT be covered by your snow thrower's warranty.
Always turn off the snow thrower's engine and remove the safety key prior
to replacing shear pins.
position, move shift lever
(a)
(b)
Figure 19
CAUTION
WARNING
OPERATION
16