Ostarz SR-Q2100 Guia De Inicio Rapido página 9

SR- Q2100
.................................................................................................................................................................................................................................................................................................
Resets items and switch measurement unit:
1. Press down the "Select" button for 3 seconds to enter in Setup Mode
2. Pressing the "Select "button to cycle (switch) through DST/ODO/Distance unit. And
pressing"Reset/Mark" button to resets parameters or change distance unit
3. Pressing "Select"button for 3 seconds to closes Setup mode.
2. Location Back mode
In bike mode, press the "Power" button switches to Location Back mode .Press
the "Select" button to cycle through waypoint A~D.
Set Waypoint:
1. Pressing the "Select" button for 3 seconds to open Setup mode
2. Pressing "Reset/Mark" button resets the waypoint. The DTG for the newly marked
point should blinks and display "0.00".
3. Pressing the "Select" buttons for 3 seconds to close the Setup mode, the waypoint has
now been marked
Route Plan mode
In Location Back mode, press "Power "button to switch to Route Plan mode . Pressing the
"Select" button to move forward or "Start /Stop" button to move backward between route
destinations ID 1~ 99
.................................................................................................................................................................................................................................................................................................
www.Qstarz .com
1) Estimated time of arrival shown as TOA.
2) Estimate direct line distance shown as DTG in MI or KM.
3) Current speed shown as mi/h or km/h.
4) Digital compass arrow pointing towards the destination.
English
9