essentiel b EBA 452c Manual De Utilización página 16

use
Fully unwind the power cord and plug it into an earthed wall socket.
1.
Press button 1, 2 or 3 on the control box to operate the fan at the desired speed:
2.
1: low speed
2: medium speed
3: high speed
Press the 0 button to stop the fan.
Adjust the tilt angle by pressing on the guard (see figure
3.
opposite).
Thermal safety device
Your fan is equipped with a thermal safety device that
•
automatically cuts off the power supply to the motor in the event of overheating.
Should this occur, take your fan to your retailer's after-sales service to have the fuse
•
replaced.
cleaning
Unplug the fan from the socket before cleaning or
•
dismantling the guards.
You can remove the front and rear guards for cleaning.
1.
To remove the front guard: unhook the five locking clips and remove the screw and lock
nut from the guards.
To remove the blades: unscrew the screw holding the blades on the shaft of the motor
unit.
To remove the rear guard: unscrew the four screws holding the rear guard onto the motor
unit.
Remove dust with a soft, dry cloth.
2.
15
V.4.0
use