Using The Winch - DRAGON WINCH MAVERICK DWM 13000 HD Manual Del Usuario

Ocultar thumbs Ver también para MAVERICK DWM 13000 HD:
Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 160
i
iMPOrtant
1. Make sure that the electrical connections were
made correctly for your winch model.
2. The battery must be in a good condition.
3. Make sure that the electric cables are caught
by moving parts of the winch or vehicle.
4. Check the connections and the cables for da-
mage regularly.
5. Tarnished or rusty wires reduce the efficiency
of the whole system.
6. All connections must be kept clean, which will
positively impact on their life and efficiency.

usiNg tHe WiNcH

i
iMPOrtant
Before loading the winch, it is recommended to
test its operation by unwinding and winding the
rope a few times. It is essential to get to know
the correct operation of the winch, both visually
and acoustically.
pulling another vehicle or cargo
If you use the winch to pull another vehicle or cargo, put
the vehicle hand brake on and put stop blocks under whe-
els.
Pull the necessary length of rope out and anchor it in the
appropriate place.
Gear lever located on the gear housing works as follows:
1. To disengage, switch gear transmission lever to
"OUT" or "LUZ," it will allow to unwind the rope freely.
DO nOt start tHE MOtOr in tHis POsitiOn!
2. To start the winding, before starting the motor,
switch the lever to "IN" or "PRACA." The winch is ready to
work.
Do Not stArt tHe Motor beFore tHe geAr HAs
eNgAgeD. puLL For rope to protect tHe geAr.
Before you begin, please check again all the connections,
rope and cables.
Hook the remote control to the winch. For safety reasons,
it is recommended to sit in the driver's place while pul-
ling.
pulling on your own
When pulling your car with the winch on your own, start
the car engine, release the hand brake, switch the gears to
neutral, do not "help" the winch with the car engine.
Control the winch using "IN" and "OUT" buttons located
on the controller. Check regularly if the rope is wound on
the drum correctly.
If you stop the winch under load, put the stop blocks under
the wheels of the vehicle or the load. When putting the
stop blocks, do not stand behind the vehicle/load.
www.dragonwinch.com
gb


Publicidad

Tabla de contenido
loading

Tabla de contenido