Front Panel; Rear Panel - Work Pro WPE 26N Guía Rápida

WPE 26N (Controls & Connections)

FRONT PANEL

1. USB Port: Allows WPE 26N to PC connection for device configuration.
2. SIGNAL LEDs: These green LEDs light when they detect signal in their respective input or output.
3. CLIP LEDs: These red LEDs light up when the signal level at the respective input or output reaches
distortion threshold. Reduce the level to get, at most, a slight flicker.
4. MUTE: These keys "mute" manually input or output respectively.
5. LCD: 2x 16 character LCD that shows the accessible fuctions via the encoder.
6. ENCODER: Using a selectable menu you can change the gain parameters and Delay both
inputs as outputs.
In the Options tab, you can change the display contrast and to show (in the Connections section) the
DHCP IP address, the IP address manually and device MAC.

REAR PANEL

1. LAN Connection: Allows to connect WPE 26N to a LAN for device configuration and to integrate it in a device
network. Conect the devoice to a LAN netwoek using a Cat5 cable with RJ45 connectors.
2. OUTPUTS 1-6: XLR 3 pin balanced connectors for output.
3. INPUTS 1-2: XLR 3 pin balanced connectors for input.
4. Power switch.
5. Power connector: Use the supplied IEC / Schuko to power the unit.
Quick Guide
- 2 -
WPE 26N