Work Pro WPE 26N Guía Rápida página 4

Installing WORKCAD software
1. Insert CD that comes with the unit
2. A window opens to inform the start of software installation process. Click Next and follow the steps for the installation
process.
NOTE: After the installation, a window informs you that a new extension (* WPJ) is associated to WORKCAD. This
extension is used by projects created.
WPE 26N (Connection)
WPE 26N can be connected in to network devices n two different ways and to configure its settings with WORKCAD
software.
USB: connecting a standard USB cable from the front connector to a computer with the software installed.
ETHERNET: Using a Cat 5 cable with RJ 45 and connecting the device to a LAN. In this case is advisable that the network
has DHCP, which will provide a valid IP address to the device.
In the same network must be connected a computer with WORKCAD control software installed
NOTE: If your network has no DHCP connection, the device will assign to WPE 26N an IP within 169.254.XX range,
being XX a direction supplied by the device upon its connection to not interfere with other devices in the same network.
WORKCAD software will detect the device for configuration.
WORKCAD (Main Screen)
WORKCAD software supports multiple WORK compatible devices. The generic interface is common to all were d
ifferences by controls and parameters capabilities and configuration of each individual device type.
Themain screen shows the large blocks into the program.
PROJECT
INSPECTOR
Quick Guide
- 3 -
WPE 26N
www.work.es