Work Pro WPE 26N Guía Rápida página 6

WORKCAD (Link)
The parameters modifications made on a virtual device loaded from the library can be dumped quickly on a physical
device. To do this:
1. Press the Setup function
2. It shows a window with the connection information (IP, Subnet, both Auto and Manual, MAC, etc), and a
LINK tab.
NOTE: When working OFFLINE these fields are empty. Once connected to a physical device, it is possible
enter on this tab to view the information)
3. Press LINK, will display a window with the physical devices connected to the network (with its name and MAC)
4. After selecting the device a window remind you that the virtual configuration will be recorded on the the physical
device deleting the previous values.
5. Press Accept. A synchronization bar between units will be showed.
6. At the end, check that the unit present in Project Inspector has its LED in green color, indicating the connection,
Therefore, the configuration made in the virtual device is dumped on the physical.
Quick Guide
- 5 -
WPE 26N
www.work.es