How To Operate The Fusion 20 Ix - Clarke Technology ALTO FUSION 20I Manual De Instrucciones

Figure 26
Figure 27
Figure 28
Page -34-
J
CLARKE TECHNOLOGY Operator's Manual -Fusion 20 Burnisher

HOW TO OPERATE THE FUSION 20 IX

1. Release the parking brake. See figure 22,
page 26.
2. Turn the key switch "ON".
3. Put the pad housing in the down position by
pulling up on the control handles. See figure
23, page 26.
4. Hold the control handles as shown in figure
26.
5. When either the right or left forward/reverse
switch (figure 27, item "B") is pushed in, the
pad motor will start and the traverse motor will
propel the machine forward.
6. Control the speed of traverse by using the
speed control knob. See figure 27, item "J".
7. To stop, release the forward/reverse switch.
8. To reverse the machine, push in the reverse
switch (figure 27, item "H") and either the right
or left forward/reverse switch (figure 27 , item
"B") at the same time.
9. To stop, release the forward/reverse switch.
10. When you stop the machine, be sure to turn
off the key switch (figure 27, item "A") and set
the parking brake.
Adjusting Pad Pressure Fusion 20 IX
To increase or decrease the pad pressure:
1. Remove or hold up the battery cover.
2. Turn the pad pressure knob (figure 28 )
clockwise to increase pad pressure and
counter clockwise to decrease pad pressure.
Use the pad pressure gauge to determine the
best setting. The needle should stay in the
green area.