BABYTREND MUV HC57 E Serie Manual De Instrucciones página 11

CAR SEAT
INFANT CAR SEAT
WARNING:
Avoid serious
injury from falling or sliding out,
always use the Infant Car Seat
harness.
ADJUST FRAME HEIGHT
WARNING:
Do not adjust
car seat height with child in seat.
Adjust seat height before placing
your child in the car seat.
WARNING:
Always
check that the Height Adjustment
Bracket is level and both left and
right sides locked before placing
child in the car seat.
WARNING:
Never use
the car seat mode at any of the
higher positions. Always use the
car seat at the lowest position.
WARNING:
Never rest the
height adjustment bracket on
the locking pins.
23) • Squeeze both left and right Release
Handles of the Height Adjustment Bracket
and adjust to the lowest position (Fig. 23a).
DO NOT adjust with child in the seat.
ATTENTION:
The Height Adjustment Bracket must be set at the
lowest postion before placing car seat (Fig. 23b).
21
Copyright © 2020, Baby Trend Inc., All Rights Reserved. Todos los derechos reservados. Tous droits réservés.
Release Handle
Fig. 23a
Highest Position
Lowest Position
Locking Pin
Fig. 23b
TO ATTACH CAR SEAT
24) • Connect the Car Seat and lock into
place (Fig. 24a). Make sure its locked
firmly in place before use (Fig. 24b).
TO REMOVE CAR SEAT
25) • Detach Car Seat from Upper Frame
Assembly by pushing both modular
release buttons on each side of the
seat and lifting seat upwards
(Fig. 25).
.
CAR SEAT MODE
Face in either direction,
front or backwards.
Infant car seat sold separately
Copyright © 2020, Baby Trend Inc., All Rights Reserved. Todos los derechos reservados. Tous droits réservés. Copyright © 2017, Baby Trend Inc., All Rights Reserved. Todos Los Derechos Reservados.
CAR SEAT
Fig. 24a
Fig. 24b
Fig. 25
22