INTRODUCTION
Before starting operations in this section:
•∙Place∙air∙conditioner∙near∙a∙power∙supply∙outlet.∙
•∙As∙shown∙in∙Fig.5∙and∙Fig.5a,∙install∙the∙exhaust∙hose,∙and∙install∙the∙window∙slider∙into∙the∙window.
•∙Insert∙the∙power∙cord∙into∙a∙grounded∙AC115V/60Hz∙socket.∙
•∙Press∙the∙POWER∙button∙to∙turn∙on∙the∙air∙conditioner.∙
Before using
Notice: Operation temperature range:
Maximum cooling
DB/WB∙(℉/℃)
95/(75℉/27.8℃)
•∙Allow∙unit∙to∙sit∙in∙upright∙position∙for∙at∙least∙2∙hours∙prior∙to∙first∙use.
•∙Check∙to∙make∙sure∙the∙exhaust∙hose∙has∙been∙installed∙properly.
•∙Check∙to∙make∙sure∙the∙rubber∙drain∙plug∙is∙securely∙plugged∙into∙the∙drain∙on∙the∙back∙of∙the∙unit∙to∙prevent∙water∙leaks.
•∙Check∙to∙make∙sure∙the∙air∙conditioner∙is∙on∙a∙flat∙surface.
Cautions for cooling and dehumidifying operations:
•∙∙ I f∙you∙turn∙the∙air∙conditioner∙off∙and∙immediately∙restart∙it,∙allow∙3∙minutes∙for∙the∙compressor∙to∙restart∙cooling.∙
•∙In∙the∙event∙of∙a∙power∙failure,∙wait∙3∙minutes∙before∙restarting∙the∙unit.
•∙Check∙to∙make∙sure∙the∙power∙supply∙meets∙requirements.
•∙The∙socket∙is∙for∙AC∙use.∙
•∙Do∙not∙share∙one∙socket∙with∙other∙appliances.∙
•∙Power∙supply∙is∙AC115V,∙60Hz.
Conduct a Power Plug Check:
•∙Press∙the∙RESET∙button∙on∙the∙power∙cord.
•∙Plug∙cord∙into∙an∙electrical∙outlet.
•∙Press∙the∙TEST∙button∙on∙the∙power∙cord.∙The∙RESET∙button∙should∙pop∙up.
•∙Press∙the∙RESET∙button∙for∙use.
•∙Do∙not∙use∙the∙air∙conditioner∙if∙the∙test∙fails.∙The∙green∙light∙on∙the∙power∙cord∙will∙turn∙on∙if∙the∙plug∙is∙working∙properly.
Minimum cooling
64/(54℉ /12.2℃)
7
ARP-7120/ARP-7120H
Fig.5
Fig.5a
Fig.6
drain hose