Installation Instructions - Magic Chef MCSCD6W5 Manual De Usuario

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

INSTALLATION INSTRUCTIONS

WARNING: Electrical Shock Hazard - Disconnect electrical power before installing dishwasher. Failure to do so
can result in electrical shock or death.
Installation of water supply pipes or electrical outlets should be performed by qualified professionals.
Set up the dishwasher on a countertop with a minimum clearance of 17.75" to the cabinet above and so the
appliance is not overhanging the edge of the countertop. Make sure that the unit is close enough to electrical
and water supply for the hoses and cord to reach, and that the surface is capable of supporting the weight of the
dishwasher fully loaded. Have 2 people move into position to prevent injury.
ELECTRICAL REQUIREMENTS
The electrical supply should be a properly installed and grounded 3-prong outlet that meets all local codes and
standards on a 10A circuit. It is recommended to use a dedicated circuit with a time delay fuse or circuit breaker.
Using with an improperly grounded outlet can result in a risk of electric shock. Check with a
WARNING:
qualified electrician or service representative if you are not sure whether the appliance is properly grounded.
DO NOT modify the plug in any way. If it does not fit the outlet, have a proper outlet installed by a qualified
electrician.
DO NOT use an extension cord or an adaptor plug with this appliance.
WARNING:
The dishwasher should be placed near the water supply (faucet) and a sink for draining, as well as a properly
installed and grounded electrical outlet. Position the appliance in the desired location. It can be up against a wall
in the back or on the sides if needed. The water inlet and drain can be set to face to the right or left as needed.
WATER CONNECTION
Your dishwasher includes a 'Quick Connect' assembly that includes an inlet and a drain hose. The faucet adapter
must first be installed on the faucet before you can connect the dishwasher. This adapter is included inside your
dishwasher and is compatible with faucets using either male (outside) or female (inside) threads on the aerator.
Please check and make sure you have all parts and locate the water inlet and drain ports on the back of the washer.
Rear of Dishwasher
a
b
c
Inlet
Hose
d
e
h
i
Faucet Adapter
9
Figure 4
Drain Hose
f
g
j
k
l
m
n
Quick Connect

Publicidad

Capítulos

Tabla de contenido

Solución de problemas

loading

Este manual también es adecuado para:

Mcscd6b5

Tabla de contenido