Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Read and follow all instructions and Safety Precautions before using this
The FLG5 Suction-feed Spray gun is fitted with a 1.8mm nozzle for topcoat applications.
The FLG5 Spray gun is approved to ATEX regulations 94/9/EC, protection level;
Important: These spray guns are suitable for use with both water-based and solvent-based
coating materials. The design uses EPA compliant atomising (DeVilbiss Trans-Tech®)
technology to reduce overspray and improve coating efficiency. Nozzles and needles are
manufactured in stainless steel. These guns are not designed for use with highly corrosive
and/or abrasive materials and if used with such materials it must be expected that the need for
cleaning and/or replacement of parts will be increased. If there is any doubt regarding the
suitability of a specific material contact your local Distributor or Finishing Brands UK Limited
direct.
Air supply connection -
Maximum static air inlet pressure -
Nominal gun inlet pressure with gun triggered -
Maximum service temperature -
Gun weight -
Air flow -
Gun body
-
Nozzle
-
Needle
-
Cup
-
Finishing Brands UK Limited reserves the right to modify equipment specification without prior
notice.
Operation Manual
FLG5 – Suction-feed Spray Gun
Description
II 2 G X. Suitable for use in Zones 1 and 2
Specification
Materials of Construction
Aluminium
Stainless steel
Stainless steel
Aluminium and steel
Important
equipment
Universal ¼" BSP and NPS
P
= 12 bar (175 psi)
1
2.4 bar (35 psi)
40°C
930 g
277 l/min (9.8 cfm)
2
© 2012 Finishing Brands UK Ltd.
Publicidad
Tabla de contenido
