Operation And Settings - Briteq bt-626 Manual De Instrucciones

ENGLISH
CONNECTIONS
DANGER: The electrical installation should be carried out by qualified personal only, according to
the regulations for electrical and mechanical safety in your country.
The input terminals are protected by a metal cap to avoid touching the contacts while the unit is in operation.
Remove this cap for the installation of the wiring. The BT-626 can be wired in 2ways:

3PHASE / 4WIRE: this is by far the best way to use the BT-626 at its full capacity! (16,5kW)
The 3 phase wires must be connected directly to the corresponding V1/V2/V3 terminals.
Connect the neutral (N) to the N-terminal.
Don't forget to connect the earth connection properly to the N-terminal!
See the wiring diagram for correct wiring.

1PHASE / 2WIRE: this is an alternative way to connect the BT-626, in this case it can NOT be used
at its full capacity! (only 9,6kW)
Use the 2 metal bridges (included) to connect the V1/V2/V3 terminals together.
The phase wire must be connected directly to one of the V1/V2/V3 terminals.
Connect the neutral (N) to the N-terminal.
Don't forget to connect the earth connection properly to the N-terminal!
See the wiring diagram for correct wiring.
Don't forget to put the protective metal cap back in place after the installation of the wiring!

OPERATION AND SETTINGS

DETECT THE PRESENCE OF A DMX-SIGNAL:
Once a DMX-signal is detected, the decimal point after the first digit starts blinking.
SET THE DMX ADDRESSES:
You can set the DMX addresses in 2 ways:
SET BEGIN ADDRESS FOR CH1:
 Press the DMX-button for about 3seconds to enter address setup mode: the display starts blinking.
 Use the ▲/▼-buttons to set the desired start address for channel1 (somewhere between
). Channels 2 to 6 will receive consecutive addresses.
 Press the DMX-button shortly to return to normal working mode.
SET DIFFERENT ADDRESSES FOR ALL CHANNELS (SOFT PATCH):
 Press the DMX-button for about 3seconds to enter address setup mode: the display starts blinking.
 Use the ▲/▼-buttons until the display shows
 Press the FNC-button to select the different channels (first digit changes from 1 to 6) and use the
▲/▼-buttons to set the desired DMX-address for the selected channel. 2 examples:
 Set Channel1 to DMX-address 001  the display looks like this:
 Set Channel6 to DMX-address 423  the display looks like this:
 Once all channels have an address, press the DMX-button again to leave address setup mode.
BRITEQ
®
.
4/30
OPERATION MANUAL
BT-626
and