Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
UNPACKINg AND CLEANINg
Carefully unpack the machine and all loose items from the
shipping container(s). Remove the rust-preventative oil from
unpainted surfaces using a soft cloth moistened with mineral
spirits, paint thinner or denatured alcohol.
NOTICE
Do not use highly volatile solvents such as
gasoline, naphtha, acetone or lacquer thinner for cleaning your
AVIS
machine.
AVISO
ASSEMBLY
SEVERE LACERATION HAZARD. TURN
THE UNIT "OFF," DISCONNECT THE UNIT from the power
source and wait 2-1/2 minutes to allow time for internal rotating
components to stop before installing or removing accessories,
before adjusting or changing set-ups, clearing clogs or when
making repairs.
ASSEMBLY TOOLS REQUIRED
•
1/2" and 9/16" Wrench, Open-End or Socket (not supplied)
ASSEMBLY TIME ESTIMATE
Assembly for this machine takes approximately 1-2 hours.
CASTERS
1.
Locate the bag of hardware with the four 3/8 hex nuts and
four 3/8 lockwashers for the four casters.
2.
For each wheel, insert bolt from caster through the holes
(A) Fig. 3 in the base of the dust collector (three are not
shown).
3.
Place a 3/8 lockwasher (A) Fig. 4 onto each bolt.
4.
Thread 3/8 hex nut (B) Fig. 4 onto each of the four bolts
and tighten securely.
SIDE SUPPORTS
1.
Place the dust collector side support (A) Fig. 5, in an
upright position as shown.
2.
Align the two holes in the wider end of the side support (A)
Fig. 5 with the two holes (B) in the base.
3.
Insert a 5/16-18 x 5/8" hex head screw (C) Fig. 6 down
through each hole in the side support and base.
4.
Place a 5/16" lockwasher onto the hex head screw.
5.
Thread a 5/16-18 hex nut onto the hex head screw and
tighten securely.
6.
Repeat this process for the remaining side support.
7.
Fig. 6 shows both side supports attached to the base.
3
A
4
5
A
6
6
B
A
B
C
Publicidad
Tabla de contenido
