Diamond GASTRO Manual Del Usuario página 4

parti elettriche, elettroniche e tutti quei difetti che risultassero una conseguenza di un errato utilizzo
del refrigeratore stesso.
È inoltre escluso dalla garanzia qualsiasi difetto risultante di un errata o mancata manutenzione, da
un errata installazione, da conseguenze di danni di trasporto e comunque non imputabili
direttamente al costruttore.
Il costruttore si impegna inoltre alla sostituzione di quei componenti del refrigeratore anche se non
prodotti direttamente da lui, purché risultino difettosi da fabbricazione. La sostituzione è limitata
alla sola fornitura del componente franco fabbrica.
DICHIARAZIONE DI CONFORMITA
RILASCIATA DAL COSTRUTTORE
Il prodotto:
I refrigeratori per bacinelle EURO-GASTRONORM sono stati progettati e costruiti in accordo allo
standard internazionale EN 60335-2-24, EN 50081-1, EN 50082-1, 89/336/CEE e successive
modifiche direttiva compatibilità elettromagnetica, 89/392, 72/23 seguendo quanto previsto dalla
direttiva BASSA TENSIONE della COMUNITA EUROPEA del 19 Febbraio 1973.
-------------------------------------------------------------------------------------------------------------------------
PACKAGING: You should have received your refrigerator with the packing materials intact,
please check that the package is not damaged when it is delivered to you. Before removing the
refrigerator from the packing materials, check that the label FRAGILE is legible and that the arrow
points up. Check that the contents have not been damaged during shipping.
The refrigerators are packed at our facility and are delivered to the shipper undamaged and properly
packaged for transport, therefore we disclaim all responsibility for eventual damages caused during
transport.
Please store the packaging in a dry place; these materials will be necessary for shipping the unit to
the factory in case technical assistance is needed (whether under guarantee or not).
remember, however, that all of our packing materials are produced in accordance with regulations
both for packaging materials and for recycling purposes.
INSTALLATION: After removing the refrigerator from the packaging materials, leave it in an
upright position for at least 30 minutes, making sure that the various basins are correct for your
needs.
Check that the On/Off button is in the OFF position (o). Make sure that the installation area (work
counter) is not exposed to sources of heat, and that the temperature does not exceed 45°C; the
refrigerator should never be directly exposed to the heating rays originating from ovens.
Leave at least 10 cm of air space in the area of the refrigerator air ventilation system so that it can
function correctly and efficiently.
Please be informed that irregular conditions compromise both the operation and the life-time of the
refrigerator you have purchased (please note that incorrect installation of the unit will annul the
guarantee).
Once the refrigerator has been installed, plug the cord into an electric system which has been
installed according to government regulations (with a ground fault circuit breaker, a suitable
USER S MANUAL
Please
3