Diamond GASTRO Manual Del Usuario página 6

1. Check that the mains power supply is active.
2. Verify that the switch is functioning properly: in the ON position the green signal light should
be on, and, within 5 or 6 seconds, the control display should show the internal temperature of
the refrigerator; the internal temperature should be higher than that set point, otherwise the
system can not operate properly.
3. Once the unit is turned on, check that the ventilation fan is working properly.
4. The condenser (aluminium exchanger placed sideways behind the perforated grill) should expel
hot air from the entire condensing surface after about 5 minutes of operation; if you place your
hands on the condensing unit, it should not be very hot to the touch. If this component does not
heat-up (even though the fan is working) the problem may be the compressor.
The guarantee covers all parts found to have factory defects, or defects directly attributable to the
manufacturer.
The manufacturer promises to repair, at its own site, refrigerator units that have operating defects
caused by improper construction of the refrigerator unit by the manufacturer. The refrigerator must
be sent to the manufacturer in its original packaging material, prepaid; it will be repaired within a
reasonable period of time and then be returned to the client, ex factory (FOB, collect), with a 3
month guarantee on the repair(s).
The present guarantee is valid for 12 months from the date of sale of the manufacturer the date on
the shipping document or on the invoice itself will be considered the date of sale.
The present guarantee does not cover defects in electric and electronic components, nor does it
cover those defects resulting from improper use of the refrigerator itself.
The guarantee also excludes any defects resulting from improper maintenance or the lack of
maintenance, incorrect installation, defects that are a consequence of damages during shipping, and
defects not directly attributable to the manufacturer.
The manufacturer further promises to substitute all defective components of the refrigerator,
including those not directly produced by the manufacturer.
provided that they are factory related defects. The substitution is strictly limited to the component
itself, ex factory.
The product:
The counter refrigerators equipped with food storage basins are designed and manufactured in
accordance with the International Standard EN 60335-2-24, EN 50081-1, EN 50082-1, 89/336/CEE
and subsequent modification. They also follow the electromagnetic compatibility instruction
(89/392, 72/23) and in accordance with the LOW TENSION directive of the EUROPEAN
COMMUNITY, February 19, 1973 73/23
-------------------------------------------------------------------------------------------------------------------------
GUARANTEE
DECLARATION OF CONFORMITY
ISSUED BY THE MANUFACTURER
5