Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
EN
WARNING: Ensure the steam cleaner is locked onto the steam mop Body
correctly.
•
To remove the manual cleaner (6) from the steam mop body (5) press the manual steam cleaner
release button (4) and simultaneously extract the steam cleaner pulling it horizontally.
FILLING THE WATER RESERVOIR
•
Turn the water reservoir (12) anti-clockwise until the arrow on the manual cleaner aligns with the
''open padlock'' symbol and extract it [Fig. C1].
•
Remove the reservoir cap (12A) rotating it anti-clockwise and take it out. Fill the reservoir with
water up to the level indicated with MAX [Fig. C2].
•
Insert and close the rubber cap (12A) clockwise and reposition the water reservoir (12) in the suitable
housing and turn it clockwise until the arrow on the manual cleaner aligns with the ''closed padlock''
symbol.
WARNING: The metal ball attached at the bottom of the plastic tube is designed to move
freely inside the water reservoir so as to always remain in the water regardless of manual
steam cleaner tilt. Should the metal ball inadvertently remain out of the water level
slightly shake the steam cleaner so it moves freely again. The metal ball must remain
in water in order to generate steam always at the pressure of the steam control button,
regardless of tilt.
•
DO NOT leave water inside the reservoir between uses.
•
Empty the water from the reservoir (12) after each use.
WARNING: To fill the water reservoir (12) during use and clean you must ALWAYS turn off
the steam cleaner and repeat the filling operations.
FILLING THE DETERGENT RESERVOIR
•
Lift the detergent reservoir cap (14B) on the brush (14).
•
Use the detergent Doser (17) to fill the detergent reservoir (14A) with common detergent for floors/
marble/parquet according to the surface to be cleaned. When dosing pure or diluted detergent,
follow the instructions on the detergent package [Fig. D1].
•
After filling the reservoir (14A) close cap (14B) slightly pressing it.
WARNING: To fill the detergent reservoir (14A) ALWAYS SWITCH OFF the
product and wait for the BRUSH to COOL!
•
DO NOT fill the detergent reservoir (14A) while the product is in operation.
USE AS A CLEANER FOR HARD FLOORS
•
Fully unwind the power cable (10). To this end, rotate the cable hooks (5A and 5B) [Fig. E1].
•
Secure the cable (10) in the cable hook (1A) on the rear part of the handle to prevent the cable
from hindering cleaning operations [Fig. E2].
•
Connect the power cord (10) to the mains.
•
Press the on/off button (7). The steam ready warning light (8) will light up RED and after 30
seconds the boiler is ready for use [Fig. E3].
14
USE
Publicidad
Tabla de contenido
