Important Unpacking Instructions - Cuisinart Premier Serie Manual De Instrucciones

IMPORTANT
UNPACKING
INSTRUCTIONS
This package contains a Cuisinart Pre-
mier Series 9- Cup Food Processor, and
the standard parts for it: work bowl, work
bowl cover, large and small pushers, metal
chopping/mixing blade, slicing disc, shred-
ding disc, detachable disc stem for discs,
spatula and recipe/instruction book.
CAUTION: THE CUTTING TOOLS HAVE
VERY SHARP EDGES. To avoid injury
When unpacking the parts, please follow
these instructions.
1. Place the box on a low table or on
the fl oor next to the kitchen counter
or table where you intend to keep the
food processor. Be sure the box is right
side up.
2. Remove the instruction booklet and fl at
cardboard. You will see a rectangular
block of plastic foam that holds the
processor parts, each fi tted into a cav-
ity in the foam.
3. The detachable disc stem for the discs
(A) sits in a cavity in one corner of the
foam block. Remove this fi rst.
4. The bowl cover (B) sits in the center of
the foam block. Remove this next.
5. The metal chopping blade (C) sit in the
cavity. Remove it next.
6. The plastic spatula (D) is on one long
side of the foam block. Remove it next.
7. The slicing disc (E) is on the long side
of the foam block: the shredding disc
(F) is on the other side. Slide them out
WITH GREAT CARE; THE BLADES
ARE VERY SHARP.
8. Lift out the top foam block.
9. Lift work bowl (G) and large/ small
pushers (H) from the middle foam
block.
10. Lift out the middle block.
11. Now only the housing base (I) is at the
bottom of the box. Use both hands to
lift the base out of the box and place
on the counter.
12. Assemble the bowl onto the base by
positioning the handle to the left of
center and turning it counterclockwise
to lock it onto the base.
13. Save the shipping cartons and plastic
foam blocks. You will fi nd them very
useful if you need to repack the pro-
cessor for moving or other shipment.
Note: We recommend that you visit our
website, www.cuisinart.com, for a fast,
effi cient way to complete your product on
line registration.
WHEN REMOVING BLADE: CARE-
FULLY REMOVE THE METAL BLADE
BY GRASPING THE METAL BLADE BY
GRASPING THE CENTER WHITE HUB
AND LIFTING IT STRAIGHT UP. NEVER
TOUCH THE BLADES, AS THEY ARE
RAZOR SHARP.
3