Black+Decker BDEJS300 Manual De Instrucciones página 6

Circle Cutting (FIGURE G)
- Insert rip fence into slot on the right side
of saw shoe with cross bar facing up.
- Adjust rip fence so that distance from
blade to hole in cross bar is the desired
radius and tighten screw.
- Place saw so that center of hole in cross
bar is over center of circle to be cut (make
pocket cut, drill hole for blade or cut inward
from edge of material to get blade into
position).
- When saw is properly positioned, drive
a small nail through hole in cross bar into
exact center of circle to be cut. Using rip
fence as a pivot arm, begin cutting circle.
G
Pocket Cutting (FIGURE H)
A pocket cut is an easy method of making
an inside cut. The saw can be inserted
directly into a panel or board without
first drilling a lead or pilot hole. In pocket
cutting, measure the surface to be cut and
mark clearly with a pencil. Next tip the saw
forward until the front end of the shoe sits
firmly on the work surface and the blade
clears the work through its full stroke.
Switch the tool on and allow it to attain
maximum speed. Grip the saw firmly and
lower the back edge of tool slowly until the
blade reaches its complete depth. Hold
the shoe flat against the wood and begin
cutting. Do not remove blade from cut while
it is still moving. Blade must come to a
complete stop.
H
MAINTENANCE
Use only mild soap and damp cloth to clean
the tool. Never let any liquid get inside the
tool; never immerse any part of the tool into
a liquid.
IMPORTANT: To assure product SAFETY
and RELIABILITY, repairs, maintenance
and adjustment should be performed by
authorized service centers or other qualified
service organizations, always using identical
replacement parts.
ACCESSORIES
WARNING:
not recommended for use with this tool
could be hazardous.
Recommended accessories for use with
your tool are available from your local dealer
or authorized service center. If you need
assistance regarding accessories, please
call: 1-800-544-6986.
SERvICE INFORMATION
All BLAck+DeckeR Service Centers are
staffed with trained personnel to provide
customers with efficient and reliable power
tool service. Whether you need technical
advice, repair, or genuine factory replacement
parts, contact the BLAck+DeckeR location
nearest you. To find your local service
location, call: 1-800-544-6986 or visit
www.blackanddecker.com
LIMITED TWO-YEAR HOME USE
WARRANTY
Black & Decker (U.S.) Inc. warrants this
product for two years against any defects
in material or workmanship. The defective
product will be replaced or repaired at no
charge in either of two ways. The first,
which will result in exchanges only, is to
return the product to the retailer from whom
it was purchased (provided that the store is
a participating retailer). Returns should be
made within the time period of the retailer's
policy for exchanges (usually 30 to 90 days
after the sale). Proof of purchase may be
required. Please check with the retailer for
their specific return policy regarding returns
that are beyond the time set for exchanges.
The second option is to take or send the
product (prepaid) to a BLAck+DeckeR
owned or authorized Service Center for
repair or replacement at our option. Proof of
purchase may be required.This warranty does
not apply to accessories. This warranty gives
you specific legal rights and you may have
other rights which vary from state to state or
province to province. Should you have any
questions, contact the manager of your nearest
BLAck+DeckeR Service Center. This
product is not intended for commercial use.
6
The use of any accessory